
Ask A Question - Help - Register - Login

How do I remove the radio on my 2006 Honda Civic LX Sedan?

Sent to Car Experts August 14, 2006 11:14 a.m.

No Comment Added

Optional Information:
2006 Honda Civic 1.8 4-cyl.

Already Tried:
Nothing, I am just trying to install an amplifier and I need to know how to remove the radio.

Customer (name blocked for privacy)

Status: Closed Value: $8

Answer
August 14, 2006 11:42 a.m. (28 minutes and 47 seconds later)

REPLIED

Disconnect the negative battery terminal

Unclip and remove the panel below the steering wheel.
Remove the (1) Phillips screw exposed on the lower left side of the panel above the steering wheel and around the instrument cluster.

Unclip and remove the panel around top of steering wheel and instrument cluster.

Remove panel inside pocket below radio and climate controls then remove (2) 8 MM screws facing up behind panel.

Unclip and remove radio/climate control assembly. (Comes out as complete assembly)

Remove the (2) Phillips screws securing the hazard switch to the radio/climate control panel.

Remove the (2) Phillips screws securing the passenger air bag on/off light to the radio/climate control panel.

Remove (3) Phillips screws securing the a/c vent to the radio/climate control panel

Remove the (4) Phillips screws securing the climate control to the radio/climate control panel.

__________________
This is a PAY Site:
If this has Helped......Please Click the ACCEPT Button !

Feedback & / Or Bonus is appreciated.......~*~Thank You!~*~

Lurch -- Aftermarket & Factory Electronics -- 99% Positive Feedback on 1412 Car Accepts
Ford, Chev Cert, Heavy Line Mech, Mobile Electronics.Sales, Installation & Repair for 30 years.

Reply to Lurch
Sent August 14, 2006 2:15 p.m. (2 hours and 32 minutes later)

Do I have to do all of these steps to get to the rear of the radio or to completely remove it? If it is to completely remove it only what will I need to do to just get to the back of the radio? I am sorry I think I phrased my question wrong earlier. Sorry again.

Customer (name blocked for privacy)

Answer
August 14, 2006 2:20 p.m. (4 minutes and 54 seconds later)

ACCEPTED

I understand that you need to get to the back of the radio to hook up your AMP.
If you only need 2 Channels & Turn ON, you could get the Rear Channels from the Harness & the Turn ON at the Ignition Switch.
Otherwise, you do need to go thru the Removal Instructions to get to the Back of the radio.
It's not as hard as it sounds, but it will take a little time.

__________________
This is a PAY Site:
If this has Helped......Please Click the ACCEPT Button !

Feedback & / Or Bonus is appreciated.......~*~Thank You!~*~

Lurch -- Aftermarket & Factory Electronics -- 99% Positive Feedback on 1412 Car Accepts
Ford, Chev Cert, Heavy Line Mech, Mobile Electronics.Sales, Installation & Repair for 30 years.

Think you can answer this question?
Login or Become an Expert

Related Answers:

	DISCLAIMER: You acknowledge that any information you may obtain from individuals you contact through use of the Just Answer service comes from those individuals, not from Just Answer!, and that Just Answer is not in any way responsible for any of the information these third parties may supply. The site and services are provided "as is" with no warranty and no representations are made regarding the qualification of an Expert. Responses and comments on Just Answer! are for general information and are not intended to substitute for informed professional advice (such as medical, legal, investment or accounting) and do not establish a professional-client relationship. Just Answer! is not intended or designed to address EMERGENCY QUESTIONS which should be directed immediately by telephone or in-person to qualified professionals. Please carefully read the Terms of Service.

Just Answer! > Car Repair