how to adjust the transmission pressure cable on ...

Throttle Pressure cable:

See Figure 2

To inspect the throttle cable operation, remove the air cleaner and depress the accelerator cable all the way. Check that the throttle valve opens fully. If the throttle valve does not open fully, adjust the accelerator link as follows:

1. Remove the air cleaner.

2. Fully depress the accelerator cable.

3. Loosen the adjustment nuts.

4. Adjust the cable housing so that the distance between the end of boot and the stopper is 0.04 inch (01mm).

5. Tighten the adjusting nuts.

6. Recheck the adjustment.

	View Full Image

Fig. 2: Throttle cable nut adjustment locations

Shift Cable:

See Figure 3

1. Loosen the swivel nut on the manual shaft lever.

2. Push the control lever to the right as far as it will go.

3. Bring the lever back two notches to the Neutral position.

4. Place the shifter in Neutral.

5. Hold the lever, lightly, toward the R range side and tighten the swivel nut.

	View Full Image

Fig. 3: Loosen the swivel nut on the manual shaft lever

__________________
"It is much wiser and cost efficient to ask a question than to stumble blindly through your auto repairs".Please Click Accept if my answer was helpful.