Ask Your Car Question. Car Experts Answer You ASAP.

(Not a Car Question?)

how do i remove the plastic covering in the back window of ...
Sent to Car Experts March 29 07:48 PM

how do i remove the plastic covering in the back window of my mazda millenia so i can replace my speakers?

 

Optional Information:
2000 Mazda millenia 2.5 v6

Already Tried:
agony

Customer (name blocked for privacy)
Answer
March 29 8:06 PM (18 minutes and 6 seconds later)
         
REPLIEDCheck Mark
Removing rear speaker grills and glove box in between the rear speakers on back deck.
Open the glove box and notice the 4 plastic round clips that hold glove box down. Use a small tool to lift the center plastic round pin, then with it up the dime size outer clip will snap out. (with the center pushpin down it locks the clip down). With the 4 push pins out of there then box will lift out. Remove the 4 large phillips screws directly under the glove box, along the large hole where the box was removed from. Now the oval shaped plastic piece that holds the grills, will unsnap up. It's easier to look at the clips from the trunk side and use pliers to squeeze and help out of the metal, to unsnap up. Just squeeze each snap and push it out. Now you'll be able to lift it out of there to expose the 6X9's which are just screwed down.
If this is helpful please click on accept.
Thanks,
Mitch


Can I fix it? Yes I can.
Reply
March 29 8:13 PM (7 minutes and 32 seconds later)
         
Reply to Mitch's Post: I need to know how to remove the whole plastic cover in the back window because I don't have any metal clips in the speaker grilles it's all one piece
Answer
March 29 8:25 PM (12 minutes and 4 seconds later)
         
REPLIEDCheck Mark
  1. Remove the child-restraint seat anchors.
  2. Remove the C-pillar trim.
  3. Remove in the order indicated in the table.
  4. Install in the reverse order of removal.

Rear Package Front Trim Removal Note

  1. Pull the rear package front trim upward to disengage the clips and the pins from the body

Images available only to Customers.

Images available only to Customers.




I hope this helps. Please click the Accept button to close the question.
Reply
March 29 8:37 PM (11 minutes and 19 seconds later)
         
Reply to autodoc_2000's Post: how do I remove the child restraint seat anchors?
Answer
March 29 8:44 PM (7 minutes and 13 seconds later)
         
ACCEPTEDCheck Mark
  1. Remove in the order indicated in the table.
  2. Install in the reverse order of removal.

Use a screw driver to pop off the cover.

Images available only to Customers.




I hope this helps. Please click the Accept button to close the question.
1 Other Expert Agrees with this!
Think you can answer this question?
Login or Become an Expert

 

DISCLAIMER: You acknowledge that any information you may obtain from individuals you contact through use of the Just Answer service comes from those individuals, not from Just Answer!, and that Just Answer is not in any way responsible for any of the information these third parties may supply. The site and services are provided "as is" with no warranty and no representations are made regarding the qualification of an Expert. Responses and comments on Just Answer! are for general information and are not intended to substitute for informed professional advice (such as medical, legal, investment or accounting) and do not establish a professional-client relationship. Just Answer! is not intended or designed to address EMERGENCY QUESTIONS which should be directed immediately by telephone or in-person to qualified professionals. Please carefully read the Terms of Service.

Just Answer! > Car Repair