Ask Your Car Question. Car Experts Answer You ASAP.

(Not a Car Question?)

my tailights in my 86 xj aren't working but the brake ...
Sent to Car Experts October 23 10:30 PM

my tailights in my 86 xj aren't working but the brake lights and reverse lights are. none of my blinkers are working either. i checked the rear bulbs and replaced them all. I need help please. also the fuses all seem to be fine visually

 

Optional Information:
1986 Jeep xj 4x4 2.5

Customer (name blocked for privacy)
Answer
October 23 11:31 PM (1 hour and 1 minute and 3 seconds later)
         
REPLIEDCheck Mark

Hello

Look under the drivers side front wheel up in the fender well

You will see a harness with connectors in it check this first




I hope this helps if not let me know.If it did please click the {Green}accept button
A bonus is always nice and don't forget to leave feed back

thanks   Glenn
Reply
October 30 10:17 PM (6 days and 22 hours later)
         
Reply to glenn's Post: Could you please elaborate a bit more. You say look under the front wheel. That doesn't make sense to me. There's nothing under the wheel but ground. As for a wire harness I looked under the fender well and in the engine compartment on the fender well. There's wires at both places. Please could you be more specific. I do have a hanes manual but nothing in there helps, that I have time to troubleshoot. Hence the reason why I paid the $.
Answer
October 31 12:50 PM (14 hours and 33 minutes and 29 seconds later)
         
REPLIEDCheck Mark

Hello

Sorry i meant in the wheel well tucked way up inside not in the engine compartment there is a harness

Un tape it there you will see some connectors

I have found quite a few that have corroded and just came apart




I hope this helps if not let me know.If it did please click the {Green}accept button
A bonus is always nice and don't forget to leave feed back

thanks   Glenn
Reply
January 1 7:25 PM (62 days and 6 hours later)
         
Reply to glenn's Post: This answer has not helped me. I noticed a cluster of wires but I need more detail. Please help me out further.
Thank you,
Joe
Answer
January 2 11:20 AM (15 hours and 54 minutes and 38 seconds later)
         
REPLIEDCheck Mark

Hello

Joe

You will have to follow the harness look closley at all connectors

Turn the 4 way flashers on and with a test light find the wire and follow it

You will find a bad connector in there




I hope this helps if not let me know.If it did please click the {Green}accept button
A bonus is always nice and don't forget to leave feed back

thanks   Glenn
Reply
January 15 8:59 PM (13 days and 9 hours later)
         
Reply to glenn's Post: Hello,
I took out the drivers side front light. I cleaned the harness inside and out. I disconnected it and cleaned it also. All the wires appear to be fine and although a little gunk on the terminals I cleaned that also. Put it all back together and nothing. Still no tailights. theres been nothing done to have severed or frayed a wire. I don't know what to do next? Pleae help to better solve this problem.
Thank you,
Joe
Think you can answer this question?
Login or Become an Expert

 

DISCLAIMER: You acknowledge that any information you may obtain from individuals you contact through use of the Just Answer service comes from those individuals, not from Just Answer!, and that Just Answer is not in any way responsible for any of the information these third parties may supply. The site and services are provided "as is" with no warranty and no representations are made regarding the qualification of an Expert. Responses and comments on Just Answer! are for general information and are not intended to substitute for informed professional advice (such as medical, legal, investment or accounting) and do not establish a professional-client relationship. Just Answer! is not intended or designed to address EMERGENCY QUESTIONS which should be directed immediately by telephone or in-person to qualified professionals. Please carefully read the Terms of Service.

Just Answer! > Car Repair