Ask Your Car Question. Car Experts Answer You ASAP.

(Not a Car Question?)

My 1999 S-10 blazer pulls to the right and when holding it ...
Sent to Car Experts August 09 05:53 PM

My 1999 S-10 blazer pulls to the right and when holding it straight or turning left there is a low pitched noise. Sounds like from the rear. Turning right the noise goes away.

 

Optional Information:
1999 Chevrolet S10 Blazer 4.3 liter

Already Tried:
rotating tires listening to rear end while on jacks. rear wheel disc brakes left side has small groove in rotor?

Customer (name blocked for privacy)
Answer
August 9 7:19 PM (1 hour and 25 minutes and 46 seconds later)
         
ACCEPTEDCheck Mark
Is it a right pull or right drift? The difference is when pulling the steering wheel turns in direction of pull. In a drift the wheel stays straight. If it is a pull the steering linkage needs to be checked. It is either out of adjustment or bent. If it is a drift it is probably caused by a radial belt shifting out of place. Try swapping front tires. See if the drift goes away or changes directions. That would be a sure sign the tires gone bad. As far as the noise goes it sounds like a wheel bearing going bad. You can check for too much play in the bearing, but it usually requires inspection of the bearing. Pay attention to the axle shaft and the outer race for brindling. You don't hear any thing on the jackstands because the bearing has to be loaded to make the noise. I'll be around if you need more help. Please accept my answer if you are satisfied.


Please click on the accept icon in the top right side if your satisfied with my answer. Bonus and positive feedback are thanks enough Thanks 32dmadden
Reply
August 10 12:16 PM (16 hours and 57 minutes and 49 seconds later)
         
Reply to 32dmadden's Post: Can you safely say that this sound in one direction only is not common for a rear end gear going out? Thanks Steve
Answer
August 10 8:51 PM (8 hours and 34 minutes and 50 seconds later)
         
REPLIEDCheck Mark
Yes. The symptoms you discribe is for a wheel bearing.


Please click on the accept icon in the top right side if your satisfied with my answer. Bonus and positive feedback are thanks enough Thanks 32dmadden
Reply
August 11 12:26 PM (15 hours and 34 minutes and 20 seconds later)
         
Reply to 32dmadden's Post: Thanks for your help
Answer
August 11 12:40 PM (14 minutes and 38 seconds later)
         
THIS ANSWER IS LOCKED!
You can view this answer by clicking here to Register or Login and paying $3.
Think you can answer this question?
Login or Become an Expert

 

DISCLAIMER: You acknowledge that any information you may obtain from individuals you contact through use of the Just Answer service comes from those individuals, not from Just Answer!, and that Just Answer is not in any way responsible for any of the information these third parties may supply. The site and services are provided "as is" with no warranty and no representations are made regarding the qualification of an Expert. Responses and comments on Just Answer! are for general information and are not intended to substitute for informed professional advice (such as medical, legal, investment or accounting) and do not establish a professional-client relationship. Just Answer! is not intended or designed to address EMERGENCY QUESTIONS which should be directed immediately by telephone or in-person to qualified professionals. Please carefully read the Terms of Service.

Just Answer! > Car Repair