REMOVAL PROCEDURE
IMPORTANT: The door window regulator motor and door regulator are serviced as a unit.
- Remove the trim panel.
- Remove the water deflector.
- Raise the window far enough in order to gain access through the door inner panel to the window to regulator bolts.
- Remove the window to regulator bolts.
- Raise the window to the full up position.
- Tape the window in the full up position.
Images available only to Customers.
- Remove the regulator mounting bolts (1,2,3,4).
- Disconnect the electrical connector.
- Remove the regulator from the door.
INSTALLATION PROCEDURE
- Position the regulator to the door.
- Install the electrical connector. NOTE: Refer to Fastener Notice in Service Precautions. IMPORTANT: In order to ensure proper orientation of the window regulator to the door, tighten the window regulator bolts in the specified sequence (1,2,3,4).
- Install the regulator mounting bolts. Tighten Tighten the window regulator bolts to 10 N.m (89 lb in).
- Remove the tape.
- Lower the window far enough in order to gain access through the door inner panel to the bolts.
- Install the window to regulator bolts (2). Tighten Tighten the window to regulator bolts to 10 N.m (89 lb in).
- Install the water deflector.
- Install the trim panel.
Images available only to Customers.
Images available only to Customers.
__________________
I hope this helps. Please click the Accept button to close the question.

