You need to do a theft deterrent relearn procedure.Remove the battery cable for 1 minute to clear the codes so you don't need a scan tool and reconn
Time required, approximately 10 minutes.
- Insure that the battery is fully charged.
- Use the scan tool in order to clear the DTCs.
- Turn the ignition switch from the OFF position to the CRANK position attempting to start the vehicle. The vehicle will start and then stall.
- Leave the ignition switch in the ON position while observing the security indicator.
- When the security indicator turns off, which can take up to 10 minutes, turn the ignition switch off. Wait 10 seconds.
The BCM and the PCM will learn the new code on the next start attempt.
ect and proceed as follows.
Master ASE Certified.L1 Advanced Engine Performance Certified.Pa Emission Repair Technician.Just Answer Car Category Mentor.